PDA

View Full Version : Two Pin wiring to NP208 Transfer Case


britreloader
12-08-2008, 01:32 PM
There is a 2 pin weatherpack vacuum switch that screws in to the top of the transfer case. This sends a signal to the dash to turn on the 4wd indicator light that is orange. Does anyone know where I can get the wiring harness that plugs into it because my weatherpack connector is torn up.
Also where does the other end of this wiring run to?? Does it go under the dash or to the engine compartment or where?? That is all I need. Thanks for any lead you guys might have.

Muddinmanny
12-08-2008, 06:30 PM
There is a 2 pin weatherpack vacuum switch that screws in to the top of the transfer case. This sends a signal to the dash to turn on the 4wd indicator light that is orange. Does anyone know where I can get the wiring harness that plugs into it because my weatherpack connector is torn up.
Also where does the other end of this wiring run to?? Does it go under the dash or to the engine compartment or where?? That is all I need. Thanks for any lead you guys might have.

www.rockautoparts.com